Search results for 'de 1 2'

Sosaku inking brush for working the pigments and glue paste onto the carved block for printing. These are made from horse hair and are traditionally prepared by splitting and softening the hair on shark-skin or sandpaper before printing. Brushes come in 3 sizes. Learn More

Sosaku inking brush for working the pigments and glue paste onto the carved block for printing. These are made from horse hair and are traditionally prepared by splitting and softening the hair on shark-skin or sandpaper before printing. Brushes come in 3 sizes. Learn More

Traditional Japanese "ba-ren" is the pressing and rubbing tool for printing. The inner coil or "shin" consists of flat strips of bamboo twisted together into strands and then into a long cord. The cord is then coiled onto a backing disk made from either layers of washi paper, carved wood or plastic. Finally a bamboo sheath or "takenokawa" is used as a covering, with rubbing surface for printing one side and a twisted handle for the artist to hold on the other. Over time the outer sheath may need replacing due to wear and friction of printing. Our "sumi" baren is made in the traditional way with a plastic backing disk and has a finer coil. It is 130mm across and is suitable for printing the "key block" and fine details. This baren comes in a presentation box. Replacement bamboo sheaths are available to order specially. Learn More

The Hangi-toh is a cutting knife with a bevelled edge. It is used to outline areas to be kept. This is the most useful tool for the Mokuhanga artist. The tool is designed to be held blade down at roughly 90 degree angle with the flat edge of the blade towards line to be kept and the bevelled edge in the area to be carved away. A small amount of pressure is excised by placing thumb over the end of the handle slightly to the left and blade tilted to the right (if you are right handed) so that you may see the blade running down the line as you work, the blade should be guided with the other hand though care is needed not to apply too much pressure. This is the traditional method of holding the tool and, for this reason right and left handed tools are required. (Please note, left handed tools can be ordered by telephone and will take 4-6 weeks to arrive). The blade may be removed and sharpened by slipping off the ferrule. Due to the delicate and fragile nature of this tool, we cannot consider refunds for blade breakage. Please use with utmost care.

PERMITTED USES Over 18s only. Proof of age required. E-mail: info@cornelissen.com Learn More