Search results for 'order in'
19 Item(s)
Grid List
-
Roberson White Siccative
Starting at: £8.40
A strontium-based siccative, milder than cobalt driers. Add sparingly to oil colours to accelerate drying, particularly recommended for pale colours. Learn More -
Roberson Damar Varnish Low Gloss
Starting at: £8.90
Gum Damar/Turpentine. Dries hard/clear. Gives low gloss. Less prone to blooming than mastic. Non-yellowing. Removable with turpentine or white spirit. Unable to send overseas. Learn More -
Roberson Gloss Picture Varnish
Starting at: £8.70
B-67/stand oil/white spirit. Nearly colourless liquid which dries to a clear non-yellowing, non-blooming high gloss film. Unable to send overseas. Learn More -
Roberson Exhibition Varnish
Starting at: £8.10
Apply to touch dry paintings as a temporary exhibition varnish. After 6 months a final picture varnish can be applied with no need to remove Ketone resin/white spirit. Unable to send overseas. Learn More -
Roberson Matt Picture Varnish
Starting at: £8.70
Ketone resin/white spirit microcrystalline wax. Clear, tough protection without gloss. Useful overpaintings where resinous media have been used. Unable to send overseas. Learn More -
Roberson Cobalt Siccative
Starting at: £7.70
A cobalt drier in white spirit, to be added sparingly to oil colours to accelerate drying. Learn More -
Roberson Beeswax Picture Varnish
Starting at: £10.20
A final picture varnish suitable for both oil and acrylic paintings. unable to send overseas. Learn More -
Roberson Clear Shellac Varnish
Starting at: £11.50
Fast drying varnish for metal leaf. May also be used to seal absorbent surfaces prior to sizing. Cellulose based. Clean brushes with methylated spirits. Learn More -
Roberson Mastic Varnish Extra Thin
Starting at: £18.50
Roberson Mastic Varnish Extra Thin. Unable to send overseas. Learn More -
Roberson Mastic Varnish Thin
Starting at: £18.50
Roberson Mastic Varnish Thin. Unable to send overseas. Learn More -
Roberson Mastic Varnish Ordinary
Starting at: £18.50
Roberson Mastic Varnish Ordinary. Unable to send overseas. Learn More -
Roberson Extra Fine Retouching Varnish
Starting at: £8.40
Synthetic, Polaroid B67 retouching varnish made as an alternative to natural resin, Damar retouching varnish. superior non-yellowing characteristics. Less readily absorbed into painted surface and less susceptible sinking. Dries quickly to a breathable, uniform, gloss finish. Learn More -
Roberson Retouching Varnish
Starting at: £8.20
Damar resin/white spirit. Rectifies dull areas caused by sinking of paint. Also helps adhesion of succeeding layer. Finish between matt and satin. Unable to send overseas. Learn More -
Roberson Satin Picture Varnish
Starting at: £8.70
Ketone resin/standoil/white spirit. Nearly colourless liquid which dries to a clear non-yellowing, non-blooming. Unable to send overseas. Learn More -
Roberson Liquid Metal 5Ltr
Starting at: £255.80
Call to Order
5 Litre containers are not available in the shop, but only as a special order through the website or over the telephone. Roberson Liquid Metals have a rich deep colour, ideal for a wide range of applications including plaster, wood, paper & canvas. The Liquid Metal range does not tarnish and does not need to be varnished. All colours are intermixable and wash up with water. The Liquid Metal range does not tarnish and does not need to be varnished. All colours are intermixable and wash up with water. Coverage is approximately 7 square metres per litre. Two coats are required for most applications but if applied to walls or ceilings with a roller or a brush then three or four coats are recommended. Because of the highly reflective nature of the metallic paint when applying with a roller to a large area apply the paint evenly in long vertical strokes, finishing off the surface by rolling or brushing in one direction, i.e ceiling to floor. This will help to minimise overlapping and create a smooth and even finish. We recommend the use of a professional quality foam roller in order to achieve the best possible finish. When applying with a roller to a large area, apply the paint evenly in long vertical strokes. Finish off the surface by rolling one direction, i.e. ceiling to floor. This will help minimise overlapping and create a smooth, even finish. These paints can also be sprayed and this will produce the best and most consistent finish. To spray Liquid Metal Acrylics, you will need to use HVLP spray equipment with a 1.6mm or 1.8mm nozzle. To ensure proper flow, paint can be thinned with 25-30% water. Learn More -
Roberson Liquid Metal 1Ltr
Starting at: £60.30
Roberson Liquid Metal 1Ltr. Roberson Liquid Metals have a rich deep colour, ideal for a wide range of applications including plaster, wood, paper & canvas. The Liquid Metal range does not tarnish and does not need to be varnished. All colours are intermixable and wash up with water. The Liquid Metal range does not tarnish and does not need to be varnished. All colours are intermixable and wash up with water. Coverage is approximately 7 square metres per litre. Two coats are required for most applications but if applied to walls or ceilings with a roller or a brush then three or four coats are recommended. Because of the highly reflective nature of the metallic paint when applying with a roller to a large area apply the paint evenly in long vertical strokes, finishing off the surface by rolling or brushing in one direction, i.e ceiling to floor. This will help to minimise overlapping and create a smooth and even finish. We recommend the use of a professional quality foam roller in order to achieve the best possible finish. When applying with a roller to a large area, apply the paint evenly in long vertical strokes. Finish off the surface by rolling one direction, i.e. ceiling to floor. This will help minimise overlapping and create a smooth, even finish. These paints can also be sprayed and this will produce the best and most consistent finish. To spray Liquid Metal Acrylics, you will need to use HVLP spray equipment with a 1.6mm or 1.8mm nozzle. To ensure proper flow, paint can be thinned with 25-30% water. Learn More -
Roberson Liquid Metal 500ml
Starting at: £34.20
Roberson Liquid Metals have a rich deep colour, ideal for a wide range of applications including plaster, wood, paper & canvas. The Liquid Metal range does not tarnish and does not need to be varnished. All colours are intermixable and wash up with water. The Liquid Metal range does not tarnish and does not need to be varnished. All colours are intermixable and wash up with water. Coverage is approximately 7 square metres per litre. Two coats are required for most applications but if applied to walls or ceilings with a roller or a brush then three or four coats are recommended. Because of the highly reflective nature of the metallic paint when applying with a roller to a large area apply the paint evenly in long vertical strokes, finishing off the surface by rolling or brushing in one direction, i.e ceiling to floor. This will help to minimise overlapping and create a smooth and even finish. We recommend the use of a professional quality foam roller in order to achieve the best possible finish. When applying with a roller to a large area, apply the paint evenly in long vertical strokes. Finish off the surface by rolling one direction, i.e. ceiling to floor. This will help minimise overlapping and create a smooth, even finish. These paints can also be sprayed and this will produce the best and most consistent finish. To spray Liquid Metal Acrylics, you will need to use HVLP spray equipment with a 1.6mm or 1.8mm nozzle. To ensure proper flow, paint can be thinned with 25-30% water. This range of paints is suitable for exterior use but must be applied on a dry day as acrylics take longer to dry out completely than oil-based paints. Once dry the paints cure and are hardwearing. Learn More -
Roberson Liquid Metal 250ml
Starting at: £18.90
Roberson Liquid Metals have a rich deep colour, ideal for a wide range of applications including plaster, wood, paper & canvas. The Liquid Metal range does not tarnish and does not need to be varnished. All colours are intermixable and wash up with water. The Liquid Metal range does not tarnish and does not need to be varnished. All colours are intermixable and wash up with water. Coverage is approximately 7 square metres per litre. Two coats are required for most applications but if applied to walls or ceilings with a roller or a brush then three or four coats are recommended. Because of the highly reflective nature of the metallic paint when applying with a roller to a large area apply the paint evenly in long vertical strokes, finishing off the surface by rolling or brushing in one direction, i.e ceiling to floor. This will help to minimise overlapping and create a smooth and even finish. We recommend the use of a professional quality foam roller in order to achieve the best possible finish. When applying with a roller to a large area, apply the paint evenly in long vertical strokes. Finish off the surface by rolling one direction, i.e. ceiling to floor. This will help minimise overlapping and create a smooth, even finish. These paints can also be sprayed and this will produce the best and most consistent finish. To spray Liquid Metal Acrylics, you will need to use HVLP spray equipment with a 1.6mm or 1.8mm nozzle. To ensure proper flow, paint can be thinned with 25-30% water. Learn More -
Roberson Liquid Metal 30ml
Starting at: £7.20
Roberson Liquid Metals have a rich deep colour, ideal for a wide range of applications including plaster, wood, paper & canvas. The Liquid Metal range does not tarnish and does not need to be varnished. All colours are intermixable and wash up with water. The Liquid Metal range does not tarnish and does not need to be varnished. All colours are intermixable and wash up with water. Coverage is approximately 7 square metres per litre. Two coats are required for most applications but if applied to walls or ceilings with a roller or a brush then three or four coats are recommended. Because of the highly reflective nature of the metallic paint when applying with a roller to a large area apply the paint evenly in long vertical strokes, finishing off the surface by rolling or brushing in one direction, i.e ceiling to floor. This will help to minimise overlapping and create a smooth and even finish. We recommend the use of a professional quality foam roller in order to achieve the best possible finish. When applying with a roller to a large area, apply the paint evenly in long vertical strokes. Finish off the surface by rolling one direction, i.e. ceiling to floor. This will help minimise overlapping and create a smooth, even finish. These paints can also be sprayed and this will produce the best and most consistent finish. To spray Liquid Metal Acrylics, you will need to use HVLP spray equipment with a 1.6mm or 1.8mm nozzle. To ensure proper flow, paint can be thinned with 25-30% water. Learn More
19 Item(s)
Grid List
Currently Shopping by:
- Manufacturer: Roberson Remove This Item
Shopping Options
- Category
- Price
-
- £0.00 - £99.99 (18)
- £200.00 and above (1)
You have no items in your shopping basket.
- Search Brands
-